Extreme Networks ExtremeWare - Unconfigure Packet-Mem-Scan-Recovery-Mode

unconfigure packet-mem-scan-recovery-mode
ExtremeWare Software 7.3.0 Command Reference Guide 751
unconfigure packet-mem-scan-recovery-mode
unconfigure packet-mem-scan-recovery-mode slot [msm-a | msm-b | <slot
number>]
Description
Disables packet memory scanning and the recovery mode on a BlackDiamond module, and returns the
system to the configured system health check behavior.
Syntax Description
Default
N/A.
Usage Guidelines
If you disable packet memory scanning on a BlackDiamond module, the system health check system
resumes. However, if you have the system health check alarm level configured, individual packet
memory scanning is ignored.
Example
The following command disables packet memory scanning on a module installed in slot 1:
unconfigure packet-mem-scan-recovery mode slot 1
The following command disables packet memory scanning on the MSM module installed in slot B:
unconfigure packet-mem-scan-recovery mode slot msm-b
History
This command was first available in ExtremeWare 6.2.2b108.
This command was not supported in ExtremeWare 7.0.
This command is supported in ExtremeWare 7.1.0.
Platform Availability
This command is available on BlackDiamond switches only.
msm-a Specifies the MSM module installed in slot A. This is available on the
BlackDiamond chassis only.
msm-b Specifies the MSM module installed in slot B. This is available on the
BlackDiamond chassis only.
slot number Specifies a module installed in a slot.