Extreme Networks ExtremeWare - Show Slb L4-Port

588 ExtremeWare Software 7.3.0 Command Reference Guide
SLB Commands
show slb L4-port
show slb L4-port [ftp | http | https | imap4 | ldap | nntp | pop3 | smtp |
socks | telnet | tftp | web | wildcard | www | <TCP or UDP port number>]
Description
Displays the SLB configuration for the active layer 4 ports.
Syntax Description
Default
N/A.
Usage Guidelines
If you do not specify a port, configuration and status for all layer 4 ports is displayed.
Example
The following command displays the current layer 4 port configuration:
show slb L4-port
Following is the output from this command:
Port: 80 Enabled TCP idle timeout (treaper): 600 UDP idle timeout: 600
History
This command was first available in ExtremeWare 6.1.
ftp Specifies an FTP port.
http Specifies an HTTP port.
https Specifies an HTTPS port.
imap4 Specifies an IMAP4 port.
ldap Specifies an LDAP port.
nntp Specifies an NNTP port.
pop3 Specifies a POP3 port.
smtp Specifies an SMTP port.
socks Specifies a SOCKS port.
telnet Specifies a telnet port.
tftp Specifies a TFTP port.
web Specifies a Web port.
wildcard Specifies any port associated with a wildcard server.
www Specifies a www port
TCP or UDP port number Specifies a TCP or UDP port.