configure bgp peer-group route-reflector-client
ExtremeWare Software 7.3.0 Command Reference Guide 1435
configure bgp peer-group route-reflector-client
configure bgp peer-group <peer group> [route-reflector-client |
no-route-reflector-client]
Description
Configures all the peers in a peer group to be a route reflector client.
Syntax Description
Default
N/A.
Usage Guidelines
This command implicitly defines this router to be a route reflector.
The peer group must be in the same AS of this router.
Example
The following command configures the peer group outer as a route reflector client:
configure bgp peer-group outer route-reflector-client
History
This command was available in ExtremeWare 6.1.5.
Platform Availability
This command is available on all platforms.
peer group Specifies a peer group.
route-reflector-client Specifies that all the neighbors in the peer group be a route reflector client.
no-route-reflector-client Specifies that all the neighbors in the peer group not be a route reflector
client.
To Next Page
Loading...