Extreme Networks ExtremeWare - Show Inline-Power

show inline-power
ExtremeWare Software 7.3.0 Command Reference Guide 1919
show inline-power
show inline-power
Description
Displays inline power status information for the system.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
The output indicates the following inline power status information for the system:
• System maximum inline power—The nominal power available, in watts.
• Configured System Power Usage—The configured power usage threshold for the system, shown in
watts and as a percentage of available power.
The output indicates the following inline power status information for each slot:
• Main PSU Status—The operational status of the main power supply unit. The status conditions are:
— ON: Power is being provided to the PoE controller.
— OFF: Power is not being provided to the PoE controller.
— FAULT: An error has occurred.
• Backup PSU Status—The condition of the backup power device, indicated by the following
information:
— State: Present, Not Present, Fault
— Status: ACTIVATED, DEACTIVATED
Valid State, Status combinations are:
• Present, ACTIVATED
• Present, DEACTIVATED
• Not Present
• Fault
• Firmware Status—The condition of the firmware, indicated by one the following states:
— Initializing—Firmware is still coming up.
— Operational—Firmware is up and running.
— Download failure—Firmware failed to download properly.
— Needs calibrating—Firmware downloaded properly or is up and running, but values stored in
EEPROM are invalid. The unit should be returned to Extreme Networks Service for recalibration.