1502 ExtremeWare Software 7.3.0 Command Reference Guide
IP Multicast Commands
configure igmp snooping leave-timeout
configure igmp snooping leave-timeout <leave_time ms>
Description
Configures the IGMP snooping leave timeout.
Syntax Description
Default
1000 ms.
Usage Guidelines
The range is 0 - 10000 ms (10 seconds). For timeout values of one second or less, you must set the
leave-timeout to a multiple of 100
ms. For values of more than one second, you must set the
leave-timeout to a multiple of 1000
ms (one second).
The specified time is the maximum leave timeout value. The switch could leave sooner if an IGMP
leave message is received before the timeout occurs.
Example
The following command configures the IGMP snooping leave timeout:
configure igmp snooping leave-timeout 10000
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
leave_time ms Specifies an IGMP leave timeout value in milliseconds.
To Next Page
Loading...
Need help?
General
