unconfigure ppp
ExtremeWare Software 7.3.0 Command Reference Guide 1749
unconfigure ppp
unconfigure ppp [ports <portlist> | multilink <groupname>]
Description
Resets the configuration on the specified WAN ports or multilink group.
Syntax Description
Default
N/A.
Usage Guidelines
The ports or multilink group PPP configuration is reset to the default, BCP encapsulation with no
authentication required.
Example
The following command example resets the PPP parameters of all the ports in the multilink group
m_remote1 to BCP and no authentication:
unconfigure ppp m_remote1
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed. A
similar command is available on the BlackDiamond switch.
portlist Specifies the port number(s).
groupname Specifies a previously created multilink group.
To Next Page
Loading...
Need help?
General
