1440 ExtremeWare Software 7.3.0 Command Reference Guide
BGP Commands
configure bgp peer-group soft-reset
configure bgp peer-group <peer group> soft-reset {[in | out]}
Description
Applies the current input/output routing policy to the neighbors in the peer group.
Syntax Description
Default
N/A.
Usage Guidelines
The input/output routing policy is determined by the NLRI-filter, AS-path-filter, and the route-map
configured for the neighbors in the peer group on the input/output side of the router. This command
does not affect configuration of the switch.
Changes made to the parameters of a peer group are applied to all neighbors in the peer group.
Modifying the following parameters automatically disables and enables the neighbors before changes
take effect:
• remote-as
• timer
• source-interface
• soft-in-reset
• password
Example
The following command applies the current input routing policy to the neighbors in the peer group
outer:
configure bgp peer-group outer soft-reset in
History
This command was available in ExtremeWare 6.1.5.
Platform Availability
This command is available on all platforms.
peer group Specifies a peer group.
in Specifies to apply the input routing policy.
out Specifies to apply the output routing policy.
To Next Page
Loading...