configure rf-profile rts-threshold
ExtremeWare Software 7.3.0 Command Reference Guide 2001
configure rf-profile rts-threshold
configure rf-profile <name> rts-threshold <value>
Description
Specifies the request-to-send (RTS) threshold in bytes.
Syntax Description
Default
2330 bytes.
Usage Guidelines
Should you encounter inconsistent data flow, only minor modifications are recommended. If a network
packet is smaller than the preset RTS threshold size, the RTS and clear-to-send (CTS) mechanism is not
enabled. The wireless port sends RTS frames to a particular receiving station and negotiates the sending
of a data frame. After receiving an RTS, the wireless station responds with a CTS frame to acknowledge
the right to begin transmission.
Examples
The following command sets the RTS threshold to the default setting:
configure rf-profile rfprof1 rts-threshold 2330
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
name Specifies the name of the RF profile.
value Specifies the RTS threshold in bytes. Valid values are from 0 to 2347. The
default value is 2330 bytes.
To Next Page
Loading...
Need help?
General
