configure ospf cost
ExtremeWare Software 7.3.0 Command Reference Guide 1283
configure ospf cost
configure ospf [area <area identifier> | vlan [<vlan name> | all]] cost
[automatic | <cost>]
Description
Configures the cost metric of one or all OSPF interface(s) for all the interfaces within the area.
Syntax Description
Default
The default cost is automatic.
Usage Guidelines
None.
Example
The following command configures the cost metric of the VLAN accounting:
configure ospf vlan accounting cost 10
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
area identifier Specifies an OSPF area.
vlan name Specifies a VLAN name.
all Specifies all VLANs.
automatic Determine the advertised cost from the OSPF metric table.
cost Specifies the cost metric.
To Next Page
Loading...