configure sflow sample-rate
ExtremeWare Software 7.3.0 Command Reference Guide 647
configure sflow sample-rate
configure sflow sample-rate <number>
Description
Configures the sample rate at which the sFlow agent collects network traffic samples.
Syntax Description
Default
8192.
Usage Guidelines
This command configures the sample rate at which the sFlow agent collects network traffic samples.
One sample per
<number>
of packets received will be sent to the sFlow collector. If the sample rate is set
to ‘0’ (zero), no samples will be sent to the collector.
Example
The following command sets the sample rate to one packet out of every 10000:
configure sflow sample-rate 10000
History
This command was first available in ExtremeWare 7.3.0.
Platform Availability
This command is available on all platforms.
number Specifies the fraction (1/number) of packets to be sampled.
To Next Page
Loading...