704 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Status Monitoring and Statistics
enable temperature-logging
enable temperature-logging
Description
Records the system temperature in celsius for the BlackDiamond and Alpine systems to the syslog.
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
When you enable temperature logging, the temperature is recorded every hour.
To view the temperature of the system, use the
show log
command. The following is sample
temperature output from the
show log
command:
06/12/2003 19:50:59.00 <Info:ELRP> Current temperature reading [197] is 49C.
06/12/2003 18:50:59.00 <Info:ELRP> Current temperature reading [196] is 48C.
06/12/2003 17:50:59.00 <Info:ELRP> Current temperature reading [195] is 48C.
To clear all of the log statistics, including the system temperature output, use the
clear log
command.
Since the temperature is recorded based on the time you enabled temperature logging, it may take up to
one hour for a new temperature to be recorded to the syslog.
If you already enabled temperature logging, and you want to view the current temperature of the
system, do the following:
1 Disable the temperature logging feature using the following command:
disable temperature-logging
2 Re-enable the temperature logging feature using the following command:
enable temperature-logging
3 Display the syslog using the following command:
show log
Example
The following command records the system temperature to the syslog:
enable temperature-logging
History
This command was first available in ExtremeWare 6.2.2b108.
This command was not supported in ExtremeWare 7.0.
To Next Page
Loading...
Need help?
General
