1710 ExtremeWare Software 7.3.0 Command Reference Guide
T1, E1, and T3 WAN Commands
configure ports t3 framing
configure ports <portlist> t3 framing [c-bit | m13]
Description
Configure framing for a T3 link.
Syntax Description
Default
C-Bit framing is enabled by default.
Usage Guidelines
Framing is used to synchronize data transmission on the line. Framing allows the hardware to
determine when each packet starts and ends. The two choices for T3 framing are C-Bit and M13.
Example
The following command sets framing to M13 for the T3 port:
configure ports 3:1 t3 framing m13
History
This command was first available in ExtremeWare v6.1.8w3.0.1b61 WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
portlist A list of ports.
c-bit Specifies C-Bit framing.
m13 Specifies M13 framing.
To Next Page
Loading...
Need help?
General
