configure ports t3 cablelength
ExtremeWare Software 7.3.0 Command Reference Guide 1709
configure ports t3 cablelength
configure ports <portlist> t3 cablelength [349 | 900] feet
Description
Control T3 transmitter signal level for different cable lengths.
Syntax Description
Default
The default setting is 349 feet.
Usage Guidelines
The transmitter level for T3 is set by selecting a cable length in feet, from the following values: 349 or
900. Choose the next higher value if the cable length provided by your service provider does not match
one of these values. For example, choose 349 for a 50 foot cable and 900 for a 450 foot cable. The default
value is 349, which corresponds to cables in the range of 0-349 feet.
Example
The following command sets the cablelength for the T3 port:
configure ports 2:1 t3 cablelength 900 feet
History
This command was first available in ExtremeWare v6.1.8w3.0.1b61 WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when the applicable WAN module is
available.
portlist A list of ports.
feet Specifies the cable length in feet. Only the values above are allowed.
To Next Page
Loading...