Extreme Networks ExtremeWare - Show Diagnostics Cable

show diagnostics cable
ExtremeWare Software 7.3.0 Command Reference Guide 1885
show diagnostics cable
show diagnostics cable {ports {<portlist> | all}} {mode {auto | manual |
both} {detail}
Description
Displays cable diagnostics information currently stored in the Cable Diagnostics Module (CDM) data
structures.
Syntax Description
ports
Default
• ports—all: If the optional ports keyword is not used, the show listing includes all ports.
• mode—both: If the optional mode keyword is not used, data collected from both the last manual run
and the last automatic run are displayed.
• detail—detail: If the optional detail keyword is not used, a summary listing is generated.
Usage Guidelines
Use this command to display or print the following cable diagnostics data for each selected port:
• Time and date of test
• Cable length (meters)
• Pair status
• Pair skew
• Pair swap
• Fault length (meters)
• Polarity
• Speed (Mbps)
You can configure the CDM to obtain diagnostics information automatically through the configure
diagnostics cable
command; or you can manually obtain cable diagnostics at any time by issuing the
run diagnostics cable command. You can use the show diagnostics cable command to view
cable diagnostics data captured from either the latest CDM manual run or automatic run; or you can
view data captured from both the manual and automatic runs.
portlist Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
all Specifies all
“3”
series ports. The default value is all.
mode auto Specifies that cable diagnostics data collected automatically should be
displayed. The default is ‘both.’
mode manual Specifies that cable diagnostics data collected manually should be displayed.
The default is ‘both.’
mode both Specifies that cable diagnostics data collected automatically and manually
should be displayed. The default is ‘both.’
detail Specifies that cable diagnostics data should be displayed in detail format. The
default format is summary.