296 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Configuring Slots and Ports on a Switch
show ports sharing
show ports <portlist> sharing
Description
Displays port loadsharing groups.
Syntax Description
Default
N/A.
Usage Guidelines
None.
Example
The following command displays the port loadsharing group configured for port 5:4; the current master
has shifted to port 7:4 since both ports 5:4 and 5:5 of the group are not active links:
show ports 5:4 sharing
The following is the output from this command:
* admin:3 # sh port 5:4 sharing
Load Sharing Monitor
Config Current Ld Share Ld Share Link Link
Master Master Type Group Status Ups
==========================================================
5:4 7:4 r 5:4 NP 1
r 5:5 NP 1
r 7:4 A 2
r 7:5 A 1
Link Status: (A) Active, (D) Disabled, (ND) Not Distributing
(NP) Not Present, (R) Ready
Ld Share Type: (a) address based, (p) port based, (r) round robin
(dy) dynamic
History
This command was first available in ExtremeWare 6.2.2.
This command was modified in ExtremeWare 7.0.0 to support the
dynamic
algorithm.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:*, 2:5, 2:6-2:8.
To Next Page
Loading...