2130 ExtremeWare Software 7.3.0 Command Reference Guide
Configuration and Image Commands
use configuration
use configuration [primary | secondary] [slot <slot_number> | all]
Description
Configures the switch to use a previously saved configuration on the next reboot.
Syntax Description
Default
N/A.
Usage Guidelines
The keyword “configuration” can be abbreviated to “config.”
Example
The following command specifies that the next reboot should use the primary saved configuration:
use configuration primary
History
This command was available in ExtremeWare 2.0.
Support for the
<slot>
parameter was introduced in ExtremeWare 7.0.0. The
<slot>
parameter is
applicable to the Alpine and BlackDiamond chassis.
Support for the
all
keyword was introduced in ExtremeWare 7.1.0. The
all
keyword is applicable to
the Alpine and BlackDiamond chassis.
Platform Availability
This command is available on all platforms.
primary Specifies the primary saved configuration.
secondary Specifies the secondary saved configuration.
slot_number Specifies the management module or another I/O module in the specified slot
to use the saved configuration.
all Specifies the management module and all I/O modules that run software to
use the saved configuration.
To Next Page
Loading...
Need help?
General
