Extreme Networks ExtremeWare - Configure Rip Txmode

configure rip txmode
ExtremeWare Software 7.3.0 Command Reference Guide 1321
configure rip txmode
configure rip txmode [none | v1only | v1comp | v2only] {vlan [<vlan name> |
all]}
Description
Changes the RIP transmission mode for one or more VLANs.
Syntax Description
Default
v2only.
Usage Guidelines
If no VLAN is specified, the setting is applied to all VLANs.
Example
The following command configures the transmit mode for the VLAN finance to transmit version 2
format packets to the broadcast address:
configure rip txmode v1comp finance
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
none Specifies to not transmit any packets on this interface.
v1only Specifies to transmit RIP version 1 format packets to the broadcast address.
v1comp Specifies to transmit RIP version 2 format packets to the broadcast address.
v2only Specifies to transmit RIP version 2 format packets to the RIP multicast
address.
vlan name Specifies to apply settings to a specific VLAN name.
all Specifies all VLANs.