show packet miscompare
ExtremeWare Software 7.3.0 Command Reference Guide 731
show packet miscompare
show packet miscompare
<slot number>
{verbose}
Description
Captures corrupted packet data to help in troubleshooting problems.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command only at the direction of Extreme Networks personnel. Extreme Networks support
personnel can capture corrupted packet data to help in troubleshooting problems using the following
command:
show packet miscompare <slot number> {verbose}
Example
The following command captures corrupted packet data for the module in slot 5:
show packet miscompare 5
History
This command was first available in ExtremeWare 7.2.0b25.
Platform Availability
This command is available on all platforms.
slot number Specifies the slot where the I/O module is installed.
verbose (Optional) Specifies detail that may interest a developer analyzing some
system behavior at a more verbose level than provided by the debug
summary information.
To Next Page
Loading...
Need help?
General
