configure system-dump server
ExtremeWare Software 7.3.0 Command Reference Guide 2203
configure system-dump server
configure system-dump server <ip address>
Description
Configures the IP address to which to transfer a dump if the
system-dump
option is specified in the
configuration.
Syntax Description
Default
The default is 0 or “no IP”.
Usage Guidelines
The IP address specified is also used if no address is provided in the
upload system-dump
command.
The IP address must be reachable through the VLAN mgmt.
Example
The following command configures the IP address to transfer a system dump to 10.10.10.1:
configure system-dump server 10.10.10.1 3
History
This command was first available in ExtremeWare 6.2.2.
Platform Availability
This command is available on platforms with an Ethernet management port.
ip address Specifies the IP address to which to transfer a system dump.
To Next Page
Loading...
Need help?
General
