2028 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
configure wireless ports interface client-scan results
timeout
configure wireless ports <portlist> interface [1 | 2] client-scan results
timeout <number>
Description
Configures the timeout period for entries in the client scan information table.
Syntax Description
Default
600 seconds.
Usage Guidelines
None.
Example
The following command sets the timeout period to 150 seconds for entries in the client scan information
table:
configure wireless ports 1:5-1:20 interface 2 client-scan results timeout 150
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
interface Specifies an interface: 1 or 2.
number Specifies the timeout in seconds for the client scan information table. Valid
numbers are between 0 and n (any number).
To Next Page
Loading...