disable multilink
ExtremeWare Software 7.3.0 Command Reference Guide 1725
disable multilink
disable multilink <groupname>
Description
Disables an MLPPP multilink group
.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to disable a multilink group. The multilink group will stop transporting traffic across
the link.
Example
The following command disables the multilink group ml_remote:
disable multilink ml_remote
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
groupname Specifies the multilink group name.
To Next Page
Loading...