Extreme Networks ExtremeWare User Manual

enable snmp dot1dTpFdbTable
ExtremeWare Software 7.3.0 Command Reference Guide 177
enable snmp dot1dTpFdbTable
enable snmp dot1dTpFdbTable
Description
Enables SNMP GetNext responses for the dot1dTpFdbTable in the BRIDGE-MIB.
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
SNMP Get responses are not affected by this command.
To view the configuration of the dot1dTpFdb table on the switch, use the show management command.
The show management command displays information about the switch including the enable/disable
state the dot1dTpFdb table.
To restore defaults to all SNMP-related entries, including the SNMP parameters modified using the
enable snmp dot1dTpFdbTable command, use the unconfigure management command.
Example
The following command enables the dot1dTPFdb table:
enable snmp dot1dTpFdbTable
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.

Extreme Networks ExtremeWare Specifications

General

Vendor	Extreme Networks
Compatibility	Extreme Networks switches and routers
Type	Network Operating System
Functionality	Network management
User Interface	CLI
Protocols Supported	OSPF, BGP, RIP, VLAN, STP
Features	QoS, Security Features