1032 ExtremeWare Software 7.3.0 Command Reference Guide
STP Commands
enable ignore-stp vlan
enable ignore-stp vlan <vlan name>
Description
Configures the switch to ignore the STP protocol and not block traffic for the VLAN(s).
Syntax Description
Default
Disabled.
Usage Guidelines
This command is useful when multiple VLANs share the same physical ports, but only some of the
VLANs require STP protection.
Example
The following command enables the ignore-stp option on the VLAN accounting:
enable ignore-stp accounting
History
This command was first available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
vlan name Specifies a VLAN name.
To Next Page
Loading...