configure ipxsap vlan delay
ExtremeWare Software 7.3.0 Command Reference Guide 1571
configure ipxsap vlan delay
configure ipxsap vlan [<vlan name> | all] delay <msec>
Description
Configures the time between each SAP packet within an update interval.
Syntax Description
Default
The default setting is 55 milliseconds.
Usage Guidelines
If no VLAN is specified, all VLANs are configured to run IPX/SAP routing. IPX/SAP routing is enabled
by default when the IPX VLAN is configured.
Example
The following command sets the time between each SAP packet to
40
milliseconds for VLAN
accounting
:
configure ipxsap vlan accounting delay 40
History
This command was introduced in ExtremeWare 4.0.
Platform Availability
This command is available on the all “i” series systems.
vlan name Specifies a VLAN name.
all Specifies all VLANs.
msec Specifies a delay in milliseconds.
To Next Page
Loading...