Extreme Networks ExtremeWare - Enable Snmp Traps Port-Up-Down

enable snmp traps port-up-down
ExtremeWare Software 7.3.0 Command Reference Guide 181
enable snmp traps port-up-down
enable snmp traps port-up-down ports [all | mgmt | <portlist>]
Description
Enables SNMP port up/down traps (also known as link up and link down traps) for the indicated
ports.
Syntax Description
Default
Enabled.
Usage Guidelines
This command is used to enable the sending of link up and link down traps for the specified ports. To
see which ports have such traps enabled, use the show management command.
Example
The following command will enable link up or link down traps on all ports of the switch (except the
management port if it has one).
enable snmp traps port-up-down all
History
This command was first available in ExtremeWare 6.2.2
This command was modified to include the management port in ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
all Specifies that link up/down traps should be sent for all ports. This does not
include the management port which must be explicitly specified.
mgmt Specifies that link up/down traps should be sent for the management port.
This option will only appear on platforms that have a management port.
<portlist> Specifies a list of ports.