configure wireless ports interface ap-scan results size
ExtremeWare Software 7.3.0 Command Reference Guide 2017
configure wireless ports interface ap-scan results size
configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
results size <num>
Description
Sets the number of elements that the wireless interface stores.
Syntax Description
Default
128.
Usage Guidelines
Use this command to specify the size of the results table.
Example
The following command configures port 1:7 and interface 1 to store 100 elements:
configure wireless ports 1:7 interface 1 ap-scan results size 100
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
num Specifies the number of elements that the wireless interface stores. Valid
numbers are between 1 and 128.
To Next Page
Loading...
Need help?
General
