1162 ExtremeWare Software 7.3.0 Command Reference Guide
IP Unicast Commands
configure ipfdb route-add
configure ipfdb route-add [clear-all | clear-subnet]
Description
Specifies which routes are deleted and reinstalled with a new gateway.
Syntax Description
Default
The default is
clear-all
.
Usage Guidelines
To see the current setting, use the
show ipconfig
command.
Example
The following command clears only the IPFDB entries associated with the new route’s subnet:
configure ipfdb route-add clear-subnet
History
This command was first available in ExtremeWare 7.0.
Platform Availability
This command is available on all platforms.
clear-all
Clears all IPFDB entries associated with a route if a more specific route
is installed.
clear-subnet
Clears only the IPFDB entries associated with the new route’s subnet
.
To Next Page
Loading...