config inline-power backup-source
ExtremeWare Software 7.3.0 Command Reference Guide 1903
config inline-power backup-source
config inline-power backup-source [internal | none] slot <slot_number>
Description
Configures the backup power supply for the external 48V power source.
Syntax Description
Default
None.
Usage Guidelines
This commands lets you specify whether or not there is a backup power supply to the external 48V
power source. If
internal
is selected then the internal power supply will be brought up if the external
48V loses power. If
none
is selected, then no other power supply will be brought up if the external 48V
loses power. In that case, the ports will not be able to provide power.
Example
The following command sets the internal power supply as the backup power supply to the external 48V
power supply for slot 1:
config inline-power backup-source internal slot 1
History
This command was first available in ExtremeWare 7.2.
Platform Availability
This command is available on Alpine series I/O modules only.
internal Specifies that the internal power supply will serve as the backup power supply
if the external 48V power source loses power.
none Specifies that there is no backup power supply if the external 48V power
source loses power. In this case, the ports will not be able to provide power.
slot_number Specifies the slot for which the backup power supply is being configured.
To Next Page
Loading...
Need help?
General
