456 ExtremeWare Software 7.3.0 Command Reference Guide
SLB Commands
configure slb failover failback-now
configure slb failover failback-now
Description
Configures the local SLB to release the remote SLB resources if the remote SLB is alive.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
When an active SLB unit fails and recovers, and manual failback is enabled, use this command to force
the recovered SLB unit to become the active unit. Executing this command does not affect the SLB
configuration.
To enable manual failback, use the following command:
enable slb failover manual-failback
To disable manual failback, use the following command:
disable slb failover manual-failback
Example
The following command forces SLB to immediately failback to the backup unit:
configure slb failover failback-now
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...