Extreme Networks ExtremeWare - Configure Snmp Add Trapreceiver

configure snmp add trapreceiver
ExtremeWare Software 7.3.0 Command Reference Guide 113
configure snmp add trapreceiver
configure snmp add trapreceiver <ip address> {port <number>} community
{hex} <community string> {from <source ip address>} {mode [enhanced |
standard]} trap-group {auth-traps{,}} {bgp-traps{,}} {extreme-traps{,}}
{link-up-down-traps{,}} {ospf-traps{,} {ping-traceroute-traps{,}}
{rmon-traps{,}} {security-traps{,}} {smart-traps{,}} {stp-traps{,}}
{system-traps{,}} {vrrp-traps{,}}
Description
Adds the IP address of a trap receiver to the trap receiver list and specifies which SNMPv1/v2c traps
are to be sent.
Syntax Description
Default
Trap receivers are in enhanced mode by default, and the version is SNMPv2c by default.
Usage Guidelines
The IP address can be unicast, multicast, or broadcast.
An authorized trap receiver can be one or more network management stations on your network.
Authorized trap receivers must be configured on the switch for the trap receiver to receive
switch-generated traps. The switch sends SNMP traps to all trap receivers configured to receive the
ip address Specifies an SNMP trap receiver IP address.
port <number> Specifies a UDP port to which the trap should be sent. Default is 162.
hex Specifies that the value to follow is to be supplied as a colon separated string of
hex octets.
community string Specifies the community string of the trap receiver.
source ip address Specifies the IP address of a VLAN to be used as the source address for the trap
enhanced Specifies enhanced traps, which contain extra varbinds at the end.
standard Specifies standard traps, which do not constrain the extra varbinds.
auth-traps Specifies that authentication traps will be sent to the trap receiver.
bgp-traps Specifies that BGP traps will be sent to the trap receiver.
extreme-traps Specifies that Extreme Networks specific traps will be sent to the trap receiver.
link-up-down-traps Specifies that link state traps will be sent to the trap receiver.
ospf-traps Specifies that OSPF traps will be sent to the trap receiver.
ping-traceroute-traps Specifies that ping and traceroute traps will be sent to the trap receiver.
rmon-traps Specifies that RMON traps will be sent to the trap receiver.
security-traps Specifies that security traps will be sent to the trap receiver.
smart-traps Specifies that Extreme Networks smart traps will be sent to the trap receiver.
stp-traps Specifies that STP traps will be sent to the trap receiver.
system-traps Specifies that system traps will be sent to the trap receiver.
vrrp-traps Specifies that VRRP traps will be sent to the trap receiver.