1692 ExtremeWare Software 7.3.0 Command Reference Guide
PoS Commands
unconfigure ppp ports
unconfigure ppp ports
<portlist>
Description
Resets the PPP configuration parameters for the specified ports to their default values.
Syntax Description
Default
N/A.
Usage Guidelines
By default, BCP is enabled on all PoS ports. (However, ports 2 and 4 of OC-3c modules are not
members of any VLANs by default; all other ports are members of the default VLAN by default.)
Example
The following command resets the PPP configuration parameters for port 1, slot 8 of a BlackDiamond
switch to the default values:
unconfigure ppp ports 8:1
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch. A similar command is available on the Alpine
switch.
portlist Specifies the port number(s).
To Next Page
Loading...