configure slb node ping-check
ExtremeWare Software 7.3.0 Command Reference Guide 495
configure slb node ping-check
configure slb node <ip address> ping-check frequency <seconds> timeout
<seconds>
Description
Overrides the global default frequency and timeout values for this node.
Syntax Description
Default
The default frequency is 10 seconds.
The default timeout is 30 seconds.
Usage Guidelines
The frequency must be less than the timeout.
To set the global ping-check frequency and timeout, use the following command:
configure slb global ping-check
Example
The following command sets the ping-check for the node with an IP address of 10.2.1.2 to a frequency
of 30 seconds and a timeout of 90 seconds:
configure slb node 10.2.1.2 ping-check frequency 30 timeout 90
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
ip address Specifies the IP address of the node.
frequency Specifies the frequency of the ping check. The range is 1 to 60 seconds.
timeout Specifies the timeout of the ping check. The range is 1 to 60 seconds.
To Next Page
Loading...