configure wireless ports interface ap-scan send-probe
ExtremeWare Software 7.3.0 Command Reference Guide 2019
configure wireless ports interface ap-scan send-probe
configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
send-probe [on |
off]
Description
Use this command to enable the sending of probes for active scanning.
Syntax Description
Default
Off.
Usage Guidelines
Use this command to enable the sending of probes. Setting
send-probe
to
on
specifies active scanning.
Setting
send-probe
to
off
specifies passive scanning.
Example
The following example enables the port range 1:15-1:24 using interface 1 to enable probes.
configure wireless ports 1:15-1:24 interface 1 ap-scan send-probe on
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
on Specifies to send probes (active scanning).
off Specifies not to send probes (passive scanning).
To Next Page
Loading...
Need help?
General
