2090 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
show wireless ports interface client-scan results
show wireless ports [<portlist> | all] interface [1 | 2] client-scan
results
Description
Displays the current contents of the probe information table.
Syntax Description
Default
N/A.
Usage Guidelines
The output of this command displays the probe information table, which has the following fields:
Example
The following example displays the probe information table for port 1:25 and interface 2:
show wireless port 1:25 interface 2 client-scan results
This command produces output similar to the following:
Intf Source Probe REQs Last RSS Channel Last SeenClient
================================================================================
1:25:2 00:20:A6:4C:40:69 8005 52 1 19:37:36 N
1:25:2 00:09:5B:92:43:63 262 34 1 19:37:37 N
1:25:2 00:09:5B:68:27:A6 482 43 1 19:37:37 N
1:25:2 00:09:5B:66:ED:F3 390 47 1 19:37:35 N
1:25:2 00:09:5B:66:E4:C9 314 12 1 19:37:30 N
1:25:2 00:02:C7:FF:09:99 46 28 1 19:37:28 N
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
Variable Description
Intf Wireless port and interface on which this client is seen
MAC address of the source MAC address of the source
Probe REQs Number of PROBE REQ packets seen from this source
Last RSS RSSI of last received PROBE REQ packet
Channel Channel on which last PROBE REQ was received
Last Seen Time last PROBE REQ was seen from this source
Client Client is associated to the Altitude 300 (Y | N)
To Next Page
Loading...