2138 ExtremeWare Software 7.3.0 Command Reference Guide
Troubleshooting Commands
configure debug-trace card-state-change
configure debug-trace card-state-change <debug level>
Description
This command is not currently supported.
Syntax Description
Default
The default level is 0.
Usage Guidelines
This command is not currently supported.
Example
This command is not currently supported.
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
debug level Specifies a debug level:
0 — Not currently supported.
1 — Not currently supported.
2 — Not currently supported.
3 — Not currently supported.
4 — Not currently supported.
5 — Not currently supported.
To Next Page
Loading...