1912 ExtremeWare Software 7.3.0 Command Reference Guide
Power Over Ethernet Commands
disable inline-power ports
disable inline-power [ports all | <portlist>]
Description
Disables power provided by all system ports or specified ports.
Syntax Description
Default
Enable.
Usage Guidelines
You can control whether inline power is provided by all system ports or specified ports by using the
disable inline-power [ports all | <portlist>] command and the enable inline-power [ports all |
<portlist>] command. Using the disable inline-power [ports all | <portlist>] command shuts down
power currently provided by all system ports or specified ports. The system defaults to enabling power
on all 10/100 ports.
To power any port, the following conditions must be met:
• The system must be enabled for power.
• The slot must be enabled for power.
• The ports must be enabled for power.
Disabling a port providing power to a powered device (PD) immediately removes power to the PD.
Example
The following command shuts down power currently provided by port 2 on slot 3:
disable inline-power 3:2
History
This command was first available in ExtremeWare 7.2.
Platform Availability
This command is available on Alpine series I/O modules only.
ports all Disables power on all system ports.
portlist Specifies one or more slots and ports on which power will be disabled. May
be in the form 2:*, 2:5, 2:6-2:8.
To Next Page
Loading...