122 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Managing the Switch
configure snmp sysContact
configure snmp syscontact <alphanumeric string>
Description
Configures the name of the system contact.
Syntax Description
Default
N/A.
Usage Guidelines
The system contact is a text field that enables you to enter the name of the person(s) responsible for
managing the switch. A maximum of 255 characters is allowed.
To view the name of the system contact listed on the switch, use the
show switch
command. The
show
switch
command displays switch statistics including the name of the system contact.
To restore defaults to all SNMP-related entries, including the SNMP parameters modified using the
configure snmp syscontact <alphanumeric string>
command, use the
unconfigure management
command.
Example
The following command defines FredJ as the system contact:
configure snmp syscontact fredj
History
This command was first available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
alphanumeric string Specifies a system contact name.
To Next Page
Loading...