Extreme Networks ExtremeWare - Configure Debug-Trace Ipxrip-Route

configure debug-trace ipxrip-route
ExtremeWare Software 7.3.0 Command Reference Guide 2163
configure debug-trace ipxrip-route
configure debug-trace ipxrip-route <debug level>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The debug level range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for IPX RIP route errors to 2:
configure debug-trace ipxrip-route 2
Following is the log output at this level:
<DBUG:XRIP> Added route to net f0220666 g/w f0001964:00:01:30:32:8d:00, hops 2, tics 2
<INFO:SYST> Log cleared
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
debug level Specifies a debug level:
0 — None.
1 — None.
2 — Displays route additions and deletions.
3 — No additional information recorded.
4 — No additional information recorded.
5 — No additional information recorded.