Extreme Networks ExtremeWare - Configure Snmpv3 Add Target-Addr

configure snmpv3 add target-addr
ExtremeWare Software 7.3.0 Command Reference Guide 135
configure snmpv3 add target-addr
configure snmpv3 add target-addr {hex} <addr name> param {hex} <param name>
ipaddress <ip address> {transport-port <port>} {from <source IP address>}
{tag-list {hex} <tag>, {hex} <tag>, ...} {volatile}
Description
Add and configure an SNMPv3 target address and associate filtering, security, and notifications with
that address.
Syntax Description
Default
The default values are:
• transport-port—port 162
• tag-list—the single tag defaultNotify, a pre-defined value in the snmpNotifyTable
• non-volatile storage
Usage Guidelines
Use this command to create an entry in the SNMPv3 snmpTargetAddressTable. The param parameter
associates the target address with an entry in the snmpTargetParamsTable, which specifies security and
storage parameters for messages to the target address, and an entry in the snmpNotifyFilterProfileTable,
which specifies filters to use for notifications to the target address.
Example
The following command specifies a target address of 10.203.0.22, port 9990, with the name A1, and
associates it with the security parameters and filter profile P1, and the notification tags type1 and type2:
configure snmpv3 add target-addr A1 param P1 ipaddress 10.203.0.22 transport-port 9990
tag-list type1, type2
History
This command was first available in ExtremeWare 7.1.0.
hex Specifies that the value to follow is to be supplied as a colon separated string
of hex octets.
addr name Specifies a string identifier for the target address.
param name Specifies the parameter name associated with the target.
ip address Specifies an SNMPv3 target IP address.
port Specifies a UDP port. Default is 162.
source ip address Specifies the IP address of a VLAN to be used as the source address for the
trap
tag Specifies a string identifier for the notifications to be sent to the target.
volatile Specifies volatile storage.