444 ExtremeWare Software 7.3.0 Command Reference Guide
SLB Commands
configure flow-redirect service-check L4-port
configure flow-redirect <flow redirect> service-check L4-port
Description
Configures the flow redirect layer 4 port check.
Syntax Description
Default
N/A.
Usage Guidelines
This command automatically enables layer 4 port check. The layer 4 port check opens and closes the
layer 4 port specified in the flow redirect policy.
For ExtremeWare 6.2.0 and prior, the frequency of the layer 4 port check is 10 seconds, the timeout of
the layer 4 port check is 30 seconds, and you cannot configure these times.
For ExtremeWare 6.2.1 and later, configure the frequency and timeout using the following command:
configure flow-redirect timer tcp-port-check
Example
The following command configures (and enables) layer 4 port check for the flow redirect policy named
“http_flow”:
configure flow-redirect http_flow service-check L4-port
History
This command was first available in ExtremeWare 6.1.5.
Platform Availability
This command is available on all platforms.
flow redirect Specifies a flow redirect policy.
To Next Page
Loading...