256 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Configuring Slots and Ports on a Switch
disable jumbo-frame ports
disable jumbo-frame ports [<portlist> | all]
Description
Disables jumbo frame support on a port.
For PoS modules, this command applies to PoS ports when disabling jumbo-frame support changes the
negotiated maximum receive unit (MRU) size.
Syntax Description
Default
Disabled.
Usage Guidelines
On a modular switch,
<portlist>
can be a list of slots and ports. On a stand-alone switch,
<portlist>
can be one or more port numbers. For a detailed explanation of port specification, see
“Modular Switch
Numerical Ranges” or “Stand-alone Switch Numerical Ranges” in Chapter 1.
Use the
disable jumbo-frame ports
command when you no longer need jumbo frame support.
Example
The following command disables jumbo frame support on port 4 on a stand-alone switch:
disable jumbo-frame ports 4
The following command disables jumbo frame support on slot 1, port 2 on a BlackDiamond switch:
disable jumbo-frame 1:2
History
This command was first available in ExtremeWare 6.0.
This command was modified in ExtremeWare 6.1 to support PoS modules.
Platform Availability
This command is available on all platforms.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:*, 2:5, 2:6-2:8.
all Specifies all ports on the switch.
To Next Page
Loading...
Need help?
General
