Extreme Networks ExtremeWare - Show Ports Vlan Info

show ports vlan info
ExtremeWare Software 7.3.0 Command Reference Guide 301
show ports vlan info
show ports <portlist> vlan info
Description
Displays port VLAN information.
Syntax Description
Default
N/A.
Usage Guidelines
None.
Example
The following command displays VLAN information for port 2:
show ports 2 vlan info
The following is the output from this command:
Port 2
Name VID Protocol Addr Flags Proto Ports
v1 4093 ------------------ -------- ANY 2/2
#
#
Flags: (C) Domain-masterVlan, (c) Domain-memberVlan, (d) DVMRP Enabled
(E) ESRP Slave, (f) IP Forwarding Enabled, (G) GVRP Enabled
(i) ISIS Enabled, (I) IP Forwarding lpm-routing Enabled
(L) Loopback Enabled, (M) ESRP Master, (m) IPmc Forwarding Enabled
(N) GNS Reply Enabled, (o) OSPF Enabled (P) IPX SAP Enabled
(p) PIM Enabled, (R) SubVLAN IP Range Configured, (r) RIP Enabled
(S) SuperVlan, (s) SubVlan, (T) Member of STP Domain
(v) VRRP Enabled, (V) VPLS/TLS Enabled, (X) IPX RIP Enabled
(Z) Translation-Vlan, (z) Member-Vlan
(2) IPX Type 20 Forwarding Enabled
History
This command was first available in ExtremeWare 7.3.0.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:*, 2:5, 2:6-2:8.