2062 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
reset wireless ports
reset wireless ports <portlist>
Description
Resets the wireless ports to their default values.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to return a port the default values. Default values are:
• Health check—on
• IP address—192.168.0.100 + port number
• Location—Unknown Location
Example
The following example resets all the wireless ports to the default values:
reset wireless ports
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
To Next Page
Loading...