Extreme Networks ExtremeWare - Configure Snmpv3 Delete Group User

configure snmpv3 delete group user
ExtremeWare Software 7.3.0 Command Reference Guide 147
configure snmpv3 delete group user
configure snmpv3 delete group {{hex} <group name>} user [all-non-defaults
| {{hex} <user name> {sec-model [snmpv1|snmpv2c|usm]}}]
Description
Delete a user name (security name) from a group.
Syntax Description
Default
The default values are:
• sec-model—USM
Usage Guidelines
Use this command to remove the associate of a user name with a group.
As per the SNMPv3 RFC, a security name is model independent while a username is model dependent.
For simplicity, both are assumed to be same here. User names and security names are handled the same.
In other words, if a user is created with the user name username, the security name value is the same,
username.
Every group is uniquely identified by a security name and security model. So the same security name
can be associated to a group name but with different security models.
The default groups are: admin, initial, v1v2c_ro, v1v2c_rw.
The default users are: admin, initial, initialmd5, initialsha, initialmd5Priv, initialshaPriv.
Example
Use the following command to delete the user guest from the group UserGroup for the security model
snmpv2c :
configure snmpv3 delete group UserGroup user guest sec-model snmpv2c
hex Specifies that the value to follow is to be supplied as a colon separated string
of hex octets.
group name Specifies the group name to add or modify.
all-non-defaults Specifies that all non-default (non-permanent) users are to be deleted from the
group.
user name Specifies the user name to add or modify.
sec-model Specifies the security model to use.
snmpv1 Specifies the SNMPv1 security model.
snmpv2 Specifies the SNMPv2c security model.
usm Specifies the SNMPv3 User-based Security Model (USM).