Extreme Networks ExtremeWare - Show Qosprofile Ingress

show qosprofile ingress
ExtremeWare Software 7.3.0 Command Reference Guide 1893
show qosprofile ingress
show qosprofile ingress {<Ingress QOS profile>} {<portlist>}
Description
Displays ingress QoS profiles.
Syntax Description
Default
N/A.
Usage Guidelines
If you do not specify an ingress QoS profile, all ingress QoS profiles for the specified ports are
displayed.
The units displayed are the same units that you used when you configured the ingress QoS profile.
Example
The following command displays ingress QoS profile information for all ingress QoS profiles on slot 1:
show qosprofile ingress 1:*
Following is sample output from this command:
MinBw %/ MaxBw %/
Port Queue Committed-Rate Peak-Rate RED % MaxBuf %
=============================================================
1:1 IQP1 1000 k 1000 m 100 % 100 %
IQP2 0 % 100 % 100 % 100 %
IQP3 0 % 100 % 100 % 100 %
IQP4 0 % 100 % 100 % 100 %
IQP5 0 % 100 % 100 % 100 %
IQP6 0 % 100 % 100 % 100 %
IQP7 0 % 100 % 100 % 100 %
IQP8 0 % 100 % 100 % 100 %
1:2 IQP1 0 % 100 % 100 % 100 %
IQP2 0 % 100 % 100 % 100 %
IQP3 0 % 100 % 100 % 100 %
IQP4 0 % 100 % 100 % 100 %
IQP5 0 % 100 % 100 % 100 %
IQP6 0 % 100 % 100 % 100 %
History
This command was first available in ExtremeWare 7.1.
Ingress QoS profile Specifies an ingress QoS profile: IQP1 through IQP8.
portlist Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.