ExtremeWare Software 7.3.0 Command Reference Guide 1857
26 High Density Gigabit Ethernet
Commands
The High Density Gigabit Ethernet modules (also known as
“3”
series modules and Triumph modules)
are I/O modules for both the Alpine 3800 series and the BlackDiamond 6800 series chassis-based
systems. These modules support bi-directional traffic management to control the rate of information that
flows into (ingress) or out of (egress) a switched network from one individual network port.
The
“3”
series modules are designed for metro service providers and enterprise environments. In a
service provider environment, service providers can control the flow of data on a per customer basis. In
an enterprise environment, businesses can use these modules to control user access or where desktop or
server interfaces require high-density Gigabit Ethernet capability.
The
“3”
series modules also support the QoS functions, commands, and configurations described in
Chapter 7.
NOTE
The 10GX3 module does not support the enhanced QoS functions described in this chapter.
This chapter documents the
“3”
series I/O module command set.
To Next Page
Loading...
Need help?
General
