configure wireless ports location
ExtremeWare Software 7.3.0 Command Reference Guide 2037
configure wireless ports location
configure wireless ports <portlist> location <location_name>
Description
Configures the physical location of the access point (AP) for the specified port or ports.
Syntax Description
Default
Unknown Location.
Usage Guidelines
Use this command to indicate the physical location of the access point (AP) for the specified port or
ports. For example, you could designate a physical location as follows:
bldg 1, pole 14, cube 7
.
Funk Radius can use this attribute for authentication.
Example
The following command configures the location, cube_a7, on port 18:
configure wireless ports 18 location cube_a7
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
location name Identifies the location to be configured.
To Next Page
Loading...