Extreme Networks ExtremeWare - Configure Debug-Trace Bootprelay

configure debug-trace bootprelay
ExtremeWare Software 7.3.0 Command Reference Guide 2137
configure debug-trace bootprelay
configure debug-trace bootprelay <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The debug level range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for BOOTP relay errors to 3:
configure debug-trace bootprelay 3
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
debug level Specifies a debug level:
0 — None.
1 — Records error messages and tracks BOOTP messages relayed.
2 — No additional information recorded.
3 — No additional information recorded.
4 — Displays a dump of each packet.
5 — No additional information recorded.
vlan name Specifies a VLAN name.