EasyManuals Logo

Extreme Networks ExtremeWare User Manual

Extreme Networks ExtremeWare
2254 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #692 background imageLoading...
Page #692 background image
692 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Status Monitoring and Statistics
enable log debug-mode
enable log debug-mode
Description
Enables debug mode. The switch allows debug events included in log filters to be logged.
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
This command enables debug mode. Debug mode must be enabled prior to logging debug messages,
which can severely degrade performance. For typical network device monitoring, debug mode should
remain disabled, the default setting. Debug mode should only be enabled when advised by technical
support, or when advanced diagnosis is required. The debug mode setting is saved to FLASH.
Example
The following command enables debug mode:
enable log debug-mode
History
This command was first available in ExtremeWare 7.1.0.
Platform Availability
This command is available on all platforms.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Extreme Networks ExtremeWare and is the answer not in the manual?

Extreme Networks ExtremeWare Specifications

General IconGeneral
VendorExtreme Networks
CompatibilityExtreme Networks switches and routers
TypeNetwork Operating System
FunctionalityNetwork management
User InterfaceCLI
Protocols SupportedOSPF, BGP, RIP, VLAN, STP
FeaturesQoS, Security Features

Related product manuals