2036 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
configure wireless ports ipaddress
configure wireless ports <portlist> ipaddress <address>
Description
Configures the source IP address for the specified port or ports.
Syntax Description
Default
The default address is 0.0.0.0.
Usage Guidelines
The source IP address can be public or private IP addresses in class A through class C.
Example
The following command configures the default IP address for port 1:18:
configure wireless ports 1:18 192.168.0.100.18
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies the port for which the IP address is being set.
address Indicates the source IP address. The IP address must be an IP address on
the management VLAN.
To Next Page
Loading...